|
Here are the improvements I would consider making to my RIMS.
 | insert a vacuum gauge after the mash tun, but before the pump to measure
the pump suction (does anyone know where I can get one of these, which will be
ok with mash running through it?).
 | A couple of people have suggested simply putting a site gauge, attached
to the output of the mash, rather than going to the expense of a vacuum
gauge. This makes sense to me, as I am wondering how clean the vacuum
gauge can get, even with Clean In Place (CIP) cleaning, which I do. |
|
DISCLAIMER: While I hope you find this site interesting and
useful for reference purposes, I am neither a plumber nor an electrician, and
therefore cannot take any liability for any injury which may occur through
implementation of any apparatus which is based on the information contained
herein. Please feel free to use this information at your own risk.
[ Back Home]
hits since February 17, 2003
Last updated April 13, 2003
Send suggestions or comments to
lou@lousbrews.info.
|
